PE R710 Memory Upgrade
I am installing new memory modules in 2 different R710's and both have dual x5650 processors. I installed 8 x 16gb modules per system 4 per processor. I installed in, A6-A3-A5-A2 B6-B3-B5-B2 1...
View ArticlePE SC1425 Monitor?
So I was just gifted a PowerEdge SC1425 by a friend who has upgraded to a better system. I went ahead and purchased a 16GB RAM upgrade: 4X4 ECC-REG-PC2-3200-4GB from amazon that say they are are...
View ArticleClik here to view.
Do MPUIQ-VMCHS SIP Modules work on Dell PowerEdge 180AS KVM?
Hello.We have a Dell PowerEdge 180AS KVM (updated with the lastest available firmware version 1.0.3.3) and Avocent MPUIQ-VMCHS SIP Modules. According to the compatibility chart in it should work, but...
View ArticleDell T20, T1700, 9020: Motherboard pinouts: Case upgrade
Hello,I have the Dell T20 1225v3 Server and wanted to upgrade the stock case to a large aftermarket case. Has anyone done this? My main concern is the non-standard front I/O connector and was wondering...
View Articlehardware configuration for vps server
hiwe wish to put up around 20 vps guest servers each with around 100 - 200 gb hdd space and 4 to 8 gb of ram per server -- both windows / linux serversCould you kindly guide us concerning the same on...
View ArticleQuestion about iDRAC Express & LCC Repair
Hello all!I am new to working with iDRAC and LCC and am trying to fix a problem with a SMBs T610. The way it was hooked up, all ethernet connections are going through a chinsy Realtek AIB and I just...
View ArticleR815 Error code 2900:0221 CPU voltage sensor
One of our R815 servers (fitted with quad AMD 6380 Opteron CPUs) halted and powered off during the night last week and on arrival in the server room, I noticed the LCD display had turned orange with a...
View ArticleClik here to view.
C1100 Memory problem
HI,I recently upgraded my C1100 server's memory to 96GB, but there are several problems.Question 1I check the user manual, but the memory part is not understood,I now installed the 12 * Hynix 8GB 2Rx4...
View ArticleDDR3 - Synchronous Registered (Buffered) PowerEdge R710
Dear all,I am getting error on Display panel "E2111 SBE Log disabled on DIMM A3 RESEAT DIMM"i have remove and insert memory pls advise
View ArticleDDR3 - Synchronous Registered (Buffered)
Error on display panel on PowerEdge R710 Rack mounted serverE2111 SBE log disabled on DIMM A3 "RESEAT DIMM"shall i reseat to solve this issue... pls advice
View ArticleMultibit ECC errors were detected on the RAID controller. If you continue,...
Hi,I have one PE-R620 server, Morning server was stuck in post with "Multibit ECC errors were detected on the RAID controller. If you continue, data corruption can occur. Contact technical support to...
View ArticleDell PowerEdge R720 memory upgrade suggestions
Hi,I have Dell Power Edge R720 installed four 8 gb Memory totally 32 gb. Per Cpu has 16 gb memory. I wanted to upgrade these memory and bought six 16 GB ram (Dell 20D6F) module.Which configuration I...
View ArticleCan't update the Lifecycle Controller -R610 - Secure Copy Failure
I have an R610 I'm trying to update and am running into a problem.I'm trying to go from 1.3.0.350 to the current 1.7.5.4. I'm installing from within the OS (2012 R2). It starts to go and then errors...
View ArticleFan 4 speed may change depending on system configuration and option card install
On the R410 when booting up the message comes out:Fan 4 speed may change depending on system configuration and option card install.Boot up continues only after pressing F1 or F2. The 4th cooler is...
View ArticleBIOS Upgrade on Dell PowerEdge R710
We have an old PowerEdge R710 that currently has BIOS v2.0.13 installed. We recently purchased 12 16 GB DIMMs to upgrade the memory to 192 GB. I read on a separate post that in order to get the bus...
View ArticleMix and match c series nodes
If I have two different PowerEdge C6100 servers, one with 2.5" drives and one with 3.5" drives, are the nodes still compatible with one another?If I replace a node from the server with 2.5" drives with...
View ArticlePowerEdge T430 delays due to "issue with logistics"
I am not new to ordering hardware from Dell, and understand the occasional delay, but there is usually a straight forward explanation.... but not this time.Placed an order for a $16,000 PowerEdge T430...
View ArticleNot Bootin just showing light System ID button
wen the server is switched nothing is happening only the System ID button. its a PowerEdge R720.
View ArticleR410, h700, The attempted feature is not licensed to run on this system
I'm running out of time, because I have to place the server soon. But I got an old version 2013 of the H700 firmware, I decided to update it to the newest recent version @2015. But the problem is, I...
View ArticleT430 RAM
I have DELL Poweredge-T430 Server, with 1TBx4 Hard drive & 8 RAMs each 8-GB in 8 out of 12 slots.Now I want to increase it's RAM in remaining 4 slots.It is possible to use 16 GB each RAM in other 4...
View Article