Hi all,
I am trying to solve this from 1 month.
we have M1000e Blade enclosure with M620 Blade servers. I have BRCM 10GbE 2P 57810s bNDC installed which is in turn connected to fabric A M8428-k 10GbEE-FCoE/8Gb FC SW.
The problem Hyper-V which is installed on blade. when I try to configure Virtual SAN port. it is showing attached error message. which says, the device or drivers not supported and I cannot choose HBA port.
however the above blade enclosure switch supports NPIV.
also when I installed "Advanced Broadcom software program" and can create virtual port manually for HBA. but in hyper-v it is still showing the same.
any ideas. why above message appears in Hyper-V
--parkar
UAE