dear all, i have a troubleshooting on dell poweredge R910
so, for resolve this problem, I have do this configuration
- Two Processors
- Two DDR3 RDIMMs in Slots 1 and 2 of Memory Riser_A
- I/O riser installed
- One power supply
- 2.5" SAS backplane (4-drive or 16-drive) installed and connected to system board
- Control panel connected to system board
- Power Distribution Board connected to the power supply and system board
1/ if I put the CPU1 and CPU2 the server don’t boot but I have this error on the front display of server:
E1245 | CPU 2 VIO Regulator failure. Contact Support. |
E1000 | Failsafe voltage error. Contact support. |
2/if I put the CPU1 and CPU3, the server start and I can view POST but I have this error:
CPU configuration is invalid. Supported populations are CPU1 and CPU2 populated, or all sockets populated.
System halted!
I have same message if I put only the CPU1.
Please, can I have an help?? our time is really counted
I am available on skype: <ADMIN NOTE:Skype ID removed as per privacy policy>