I'm having issues being able to get the system to identify the hard drives.
THE GOAL IS RAID 5 ON 3 OF THE DRIVES
1 X250gb, 3x500 drives
1. Poweredge T110
2. 4GB of memory
Phoenix BIOS Plus Version 1.10 104
PERC S300
I get " No Boot Drive Available
Current Boot Mode is set to BIOS
F2 - System Setup"
*SATA Controller Settings (AHCI Mode)
Port A-E (OFF), eSATA Port (OFF)
Boot Mode (BIOS)
Boot Sequence (Embedded SATA DVD-ROM), only drive that is visible
Boot Sequence ( Enabled)
I restarted the computer with the System Build Utility disk in, and it actually processed to the point that I could set up RAID configuration, and it initialized windows 2008.
Once I rebooted, the system I'm back too square one.
I can't seem to get pass actually having data flow too the hard drives.