I've procured some M610 servers from ebay. No errors, and all hardware works fine. However, the CMC (v4.45) and iDRAC (v3.5) reports one of the servers has 2 processors, 24GB of RAM, and no C fabric Mezzanine board. However, the server has a single processor, 4GB RAM, and a 10GB Broadcom 57711 Mezzanine card. The other server reports all correct info.
I have logged into the racadm and run racadmresetcfg multiple times. I've updated all firmware I can get my hands on.
Again, all hardware works as required. I can Boot iSCSI on the 10GB Broadcom cards, I can install the OK and verify that the hardware is all intact, but the CMC is reporting incorrect inventory.
Server 4 is the one reporting the correct info. Server 5 is the one reporting incorrect info. Here is the version info from the CMC racadm getversion command.
server-4 BIOS 6.3.0 2013-08-15
iDRAC 3.50 2013-08-15
USC 1.3.0.3 50 2013-08-09
Diagnostics 5130A0 2013-08-09
OS Drivers 7.3.0.1 0 2013-08-21
NIC-Broadcom NetXtreme II Gigabit Ethernet (Embedded 1-1) 6.2.12 2013-08-15
NIC-Broadcom NetXtreme II Gigabit Ethernet (Embedded 2-1) 6.2.12 2013-08-15
NIC-Broadcom NetXtreme II 10 Gigabit Ethernet (Mezzanine 1C- 5.0.12 2013-08-15
NIC-Broadcom NetXtreme II 10 Gigabit Ethernet (Mezzanine 1C- 5.0.12 2013-08-15
BIOS 6.3.0 Reinstall
BIOS 6.1.0 Rollback
iDRAC 3.32 Rollback
NIC-Broadcom NetXtreme 1 and NetXtreme 2 device firmware Del 5.0.13 Rollback
NIC-Broadcom NetXtreme 1 and NetXtreme 2 device firmware Del 5.0.13 Rollback
server-5 BIOS 6.3.0 2013-08-22
iDRAC 3.50 2013-08-22
USC 1.6.0.7 3 2013-08-23
Diagnostics 5148A0 2013-08-22
OS Drivers 7.3.0.1 0 2013-08-23
NIC-Broadcom NetXtreme II Gigabit Ethernet - (Embedded 1-1) 6.2.12 2011-12-21
NIC-Broadcom NetXtreme II Gigabit Ethernet - (Embedded 2-1) 6.2.12 2011-12-21
BIOS 6.3.0 Reinstall
BIOS 6.1.0 Rollback
iDRAC 3.02 Rollback
NIC-Broadcom Firmware update package 6.0.1 Rollback