Guys,
We recently ordered 32GB of RAM (2 16's) for our R610 but cannot get the configuration right.
Our setup is as follows:
(4) 1GB sticks
(2) 16GB sticks
What is the proper way to configure this RAM installation?
We tried a lot of combinations but could not get it to be recognized. We ended up putting the original (4) 1GB sticks back in, which works fine.
We looked at this PDF, but it was not much help for us.
https://www.dell.com/downloads/emea/products/pedge/en/installing_upgrading_ddr3_memory_11g.pdf
Thank you