Last week our PE T410 had a PCIE failure on bus 0 and reboot. It hung on 'Press F1 to continue, F2 to enter setup'. Dell came out and replaced the system board but it still hangs on 'Press F1 to continue, F2 to enter setup'. There are no error messages or reason for 'Press F1 to continue, F2 to enter setup'. If I press F1 it boot up normally.
The server has 4 x 450GB SAS drive and I think an S300 controller. There is also a DVD-ROM. When the server starts, it looks like a PXE boot attempt while it looks for a DHCP server. when this fails the POST continues.
Any suggestions?