Nagios indicated that there is a critical error on our Dell 2950. We are running centos 5.8,
Is this something that we need to be concerned about?
Controller PERC 6/i Integrated (Slot Embedded)
ID : 0
Status : Critical
Name : Battery 0
State : Failed
Recharge Count : Not Applicable
Max Recharge Count : Not Applicable
Predicted Capacity Status : Failed
Learn State : Idle
Next Learn Time : 17 days 13 hours
Maximum Learn Delay : 7 days 0 hours
Learn Mode : Auto
Controllers
ID : 0
Status : Ok
Name : PERC 6/i Integrated
Slot ID : Embedded
State : Ready
Firmware Version : 6.2.0-0013
Minimum Required Firmware Version : Not Applicable
Driver Version : 00.00.06.15-rh
Minimum Required Driver Version : Not Applicable
Number of Connectors : 2
Rebuild Rate : 30%
BGI Rate : 30%
Check Consistency Rate : 30%
Reconstruct Rate : 30%
Alarm State : Not Applicable
Cluster Mode : Not Applicable
SCSI Initiator ID : Not Applicable
Cache Memory Size : 256 MB
Patrol Read Mode : Auto
Patrol Read State : Stopped
Patrol Read Rate : 30%
Patrol Read Iterations : 276
Abort check consistency on error : Disabled
Allow Revertible Hot Spare and Replace Member : Enabled
Auto replace member on predictive failure : Disabled
Load balance : Auto
Redundant Path view : Not Applicable
Thanks for any help.