Hello Everyone;
I have Dell PowerEdge C6100 Server (4 nodes) and I'm having trouble configuring the Memory on them.
Server Specs: http://www.dell.com/downloads/global/products/pedge/en/poweredge-c6100-spec-sheet-en.pdf
Server Manual: http://support.dell.com/support/edocs/systems/cp_pe_c6100/en/HOM/PDF/6100HM.pdf
So I'm trying to add 2 X 16 DDR3 RAM in to each node, however it only read one stick at a time!, in other words If I add both sticks it should read 32GB but in my case it only reads 16GB.
I tested all RAM sticks that I bought and they all work fine. I could not understand the manual "Memory Module configuration" table on how the Memeory should be set on these nodes,
I add 1 Stick to slot 1 and 12 but that did not work! I also tried number of configurations but I was unsuccessful.
Any ideas? . Thank you kindly.
