I just purchased a T610 - and the Power Button was broken. Ordered a new module - installed it. Also Updated the processors of the unit - and added 8 - 8gig memory Modules. After plugging the unit in - (both power cords) with only keyboard/mouse and monitor hooked up - the unit just sits and revs up and cycles down every 5 seconds or so. I followed a post regarding the same issue - the tech suggested that the user try each power supply independently. Done - no change. Then to go in and check the all connections (memory and CPU's properly seated) - Done - no change. Unpower the Back Plane and disconnect - Done - no Change. Remove the Perc Card - Done - No Change. After making the changes - I hoped to get some different result - Which I somewhat did - The front LEAD display showed a Power Message - Software Error - Power Asserted, Asserted. (pretty meaningful if you can understand that?). I unplugged the system - and now it's back to its rev and cycle down issue. At one point I had a blinking BLUE light (out of the back of the unit) - but I no longer have that.
ALL HELP would be GREATLY APPRECIATED!