Hello eveverybody,
I have a fresh new Dell Poweredge R430 with a SAS HBA 12GB and everything was ok.
I replaced the 12GB card by the dell SAS 6GB HBA buy on the Dell Website .MyServer wont boot correctly since i replaced it...
My scenario is :
1/ "Initializing Firmware Interfaces "- now take about 5-10 minutes to pass.
2/ Lifecycle controller wont boot and get stuck on : "Entering LCC"
3/ If my server want boot..., it take long time to be on Windows Logon page (Applying computer settings... screen) - about 5-10 minutes again.
All firmware (LCC, BIOS, HBA SAS, etc...) are up to date.
I'm using Windows 2008 R2 SP1 on it. All SAS cables and the card are correctly connected to myTL4000.
System Setup : BIOS not UEFI mode
Everyone has an idea, i'm going to be crazy...
Thank you in advance.
Benjamin. T.