Hello pals. Perc3 is beating me.
As I could see here
I have a perc 3 DC card.
Pictures attached
Here, I've seen about
[quote]
For the perc controller, pull the Raid Key and DIMM and leave out tof the server for 5-10 minutes. Put the components back in, reboot and go into the bios of the Perc controller (Cntrl-"A"). Accept the configuration changes and the controller should take the configuration off the drives.
For the system NVRAM: Note the settings in the bios. Shut the server down, set the ISA_CLR jumper, restart the server and you should get a message that the jumper is set or that there is a configuration issue. Shut the server down, remove the jumper and restart. Go into the system setup (F2), reset any settings and reboot.
[/quote]
DIMM, ok, but "raid key", what is it?
I'm trying control with perc 3 a 6-bay SCA822 (LSI) with 4 10k SCSI Maxtor hd (73,4G) and 2 10K SCSI seagate with 36Gb (raid 5 4//2) to use with linux
The mobo is a desktop one, asrock extreme 3.
I used a LSI21320R, but after a non succesfull BIOS update, I bricked it, and choose perc3 to do the work, but... it don't detects nothing, and hangs during boot, and I mind that "zeroing all" will be enough (I wish)