I am in the middle of swapping out drives on the 2950 server with SAS . I have 2 500 GB drives in slot 0 and 1 and 4 x 1TB Seagate sata drives in 2,3,4,5. When I boot and enter the SAS configuration screen all drives but drive 3 show up. The slot used to work fine before I pulled the old drives out. Could it be a configuration issue on the raid card?
I have pulled and re-seated drive 3 several times but I don't even get a little power blip like I do when I re seat all the other drives. Hardware failure? I also swapped different drives into that slot to make sure it wasn't a dead drive.
Thank you