Hi,
We have a PowerEdge R200 server with the Broadcom BCM95721 network controller. It's stuck at 100Mbps link to a 1Gig switch. We have other, older, PE servers connected to the same switch and they link up at 1Gig just fine.
I looked at firmware updates but the section is a mess and confusing as to what firmware is compatible and what version I can jump to/from.
Some info...
CentOS 5.x
2.6.18-400.1.1.el5 #1 SMP Thu Dec 18 00:59:53 EST 2014 x86_64 x86_64 x86_64 GNU/Linux
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
Link detected: yes
ethtool -i eth0
driver: tg3
version: 3.123
firmware-version: 5721-v3.65, ASFIPMI v6.25
bus-info: 0000:04:00.0
Thanks :)