As you can see from the R620 SEL below, the drives go from a “removed” state to “installed” state in a matter of 3-5 minutes. Every “removed” event results in a drive rebuild. This happens automatically.
Please suggest a fix.
Sample SEL log
Sun Oct 05 2014 02:35:45 Drive 2 is installed in disk drive bay 1.
Sun Oct 05 2014 02:33:19 Drive 2 is removed from disk drive bay 1.
Sun Jun 01 2014 02:27:06 Drive 0 is installed in disk drive bay 1.
Sun Jun 01 2014 02:24:20 Drive 0 in disk drive bay 1 is operating normally.
Sun Jun 01 2014 02:24:20 Drive 0 is removed from disk drive bay 1.
Tue May 20 2014 07:37:05 Fault detected on drive 5 in disk drive bay 1.
Mon May 05 2014 08:36:52 Fault detected on drive 0 in disk drive bay 1.
Sun Feb 23 2014 02:05:27 Drive 5 is installed in disk drive bay 1.
Sun Feb 23 2014 02:03:22 Drive 5 in disk drive bay 1 is operating normally.
Sun Feb 23 2014 02:03:22 Drive 5 is removed from disk drive bay 1.
Tue Feb 11 2014 09:15:47 Fault detected on drive 5 in disk drive bay 1.
Sun Jan 12 2014 02:19:21 Drive 2 is installed in disk drive bay 1.
Sun Jan 12 2014 02:17:31 Drive 2 in disk drive bay 1 is operating normally.
Sun Jan 12 2014 02:17:31 Drive 2 is removed from disk drive bay 1.
Fri Dec 13 2013 03:44:18 Fault detected on drive 2 in disk drive bay 1.
Thu Jun 27 2013 00:22:58 Log cleared.