Hello all,
I added a second cpu to my T610 and now I get the E1000 error. the CPU is X5650 I have 2X 16gb ram in the correct slots for each processor. If I remove one processor the system boots correctly, I have tried both processors as a single cpu setup and all is well. The processors are a matched set. This server has been operating fine for the last few months with the single CPU. As a side note I did have a issue about a month ago where when I came in one morning both power supplies had failed one would not display any light at all and the other just had the amber light. I replaced both and it has run fine since until the upgrade to 2 cpu's . Could this be caused by the power distribution board?
Thanks
Bruce